A suggestion of doing something like this might be helpful.Ĥ: I love my iFixit toolkits! But including a pair of tweezers in it would be helpful. What an evil thing Apple did there! I laid the bracket upside-down on a piece of tape, and oriented the screws around it so I'd know where they go back upon reassembly a week later. If there's a trick to this, it would be nice to have that extra instruction with the reassembly instructions, rather than "reverse order."ģ: While this is always a good idea, in the process of trying to get something done, it's easy to forget that you need to remember which screws go back where, especially the 3 different-sized screws from step 10. A mention of whether it would be safe would be nice.Ģ: I found it impossible to get the clip from step 7 back on. As a result, I bent the heck out of the battery & ordered a new one, not trusting a bent one. When you've got it right, it will feel like a 3.5mm headphone jack clicking into place (but a lot smaller).A couple of additional pointers might be helpful.ġ: I did not get all of the adhesive out from under the battery. It needs to be EXACTLY dead-on before you press it into place. If they DO look like that then your problem is likely that you don't have it aligned properly. If yours don't look like that then they will need to be repaired (sockets) or replaced (cable). Don't worry we have you covered because today. Your lightning connector is broken and now your iPhone 5S will not charge. The top of this image shows what a good socket and cable end should look like (sockets on either side, cable in the middle): How To: Replace the Lightning Connector in your iPhone 5s. This repair may resolve a host of issues like a malfunctioning microphone, slow or nonexistent charging, limited connectivity, or spotty headphone output for your iPhone 5. It is insanely easy to damage these connectors you need only have it misaligned by a millimeter and then push down with sufficient force to damage either or both sides. Replace a dirty, corroded, or damaged lightning connector, or a broken headphone jack in an iPhone 5s. If yours isn't staying in the socket then the first thing to do is to examine both the socket and the cable end for damage. Gluing the cable into place won't establish the electrical connection that needs to happen for the antenna to work. Assuming nothing is damaged (and those connectors are *really* easy to damage), once you get it aligned you just press it down to lock into place, like an old-school composite video or audio cable. The antenna wire is held in place with friction. In case it’s not apparent, I don’t have warranty, so no free apple care even if I hadn’t replaced my port and battery.Īny other advice would also be highly appreciated. I’m a bit worried I’ll break whatever isn’t broken on my phone right now if I do so, so could someone tell me whether or not this is a terrible idea as a last resort? The error posted there was code 1, not sure if that’s different from -1. A previous thread ( iPhone could not be restored unknown error 1 ) seemed to have a variety of People posting success with heating or cooling their phones.Would it be possible that this is the problem? I don’t really know what the antenna is, and why it’s at the same place as the lightning port, so I’m not sure if it’s meant to have something to do with the restore process. This time, I was a bit exasperated and didn’t spend the two hours again, and as a result it is possible the antenna isn’t in the correct position. After about two hours of fiddling I managed to get the antenna in the correct position, and relied upon the casing to keep it there. I had a lot of trouble connecting it, as earlier in the year I had replaced my lightning port (I think a faulty charger is what caused the battery issues in the first place) and the ifixit port’s antenna refused to snugly fit into the antenna’s port. It’s possible the antenna is not connected properly.An earlier thread I found whilst troubleshooting mentioned that it’s likely this is a defect in the baseband chip I guess it’s possible I somehow scratched it. Now it keeps going to the ‘plug into iTunes’ screen with the lightning connector, so I can’t get into DFU either.įrom what I understand, this is indicative of a hardware error. Upon trying to restore it (it had gone into a boot loop before and gotten stuck in the DFU Screen) iTunes gave me the dreaded error code -1. In the end, I got it out, replaced it, and closed up the iPhone again. I’ve recently replaced my iPhone 5S’s battery, which was an arduous process because it turns out my battery was forming lumps.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |